Flame failures response time of 0.8 or 3 sec |
Flame signal strength ranges from 0 to 5 VDC |
Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation |
Flame signal test jacks to measure amplifiers flame signal voltage |
Dynamic self check amplifiers test the detectors and all electronic components in the flame detection system 7800 series relay module locks out on safety shutdown with flame detection system failures |
Compatible with existing Honeywell® flame detectors |
For use with C7004, C7005, C7007, C7008, C7009, Q179 rectifying flame rods and ultraviolet flame sensor C7012A, gas, oil, coal flame sensor |
For 7800 series and R7140 relay module |