Float operated 2-pole mechanical switch |
Durable cast construction, ASTM Class 25 cast iron switch case and pump housing |
Non-clogging vortex impeller design, engineered plastic impeller with metal inserts (1 ph) |
Not affected by materials normally found in drainage and sewage pumps |
Stainless steel screws, bolts, handle, guard, arm and seal assembly |
Neoprene square ring and gasket |
Oil filled, hermetically sealed motors |
Oil-lubricated bearings |
Carbon and ceramic shaft seal |
Corrosion-resistant, powder coated epoxy finish |
Completely submersible |
Watertight and dust-tight |
Automatic reset thermal overload protection (1 ph only) |
12 in on point, 4 in off point |
High water alarms available |
10 in auto/15 in non auto, 3-wire neoprene cord and plug |
Cap/motor housing/pump housing cast iron, base cast iron or engineered plastic |
Upper and lower sleeve bearing |
Engineered plastic with metal insert impeller, Stainless steel hardware, AISI 1215 cold rolled steel motor shaft, Neoprene gasket |
Submersible sewage/effluent or dewatering pump |